Juniper PTX5000 Hardware Manual page 535

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Repeat steps 3 and 4 for the other PDU.
5.
Verify that the PDU OK
6.
LEDs are off for your specific PDU:
120-A DC PDU—Verify that the
60-A DC PDU—Verify that the
Three-phase delta AC PDU or three-phase wye AC PDU—Verify that the
is off.
NOTE: After powering off a power supply, you must wait at least 60
seconds before powering it on again.
Powering On the DC Powered PTX5000 Packet Transport Router with 60-A DC PDUs
and 60-A DC PSMs on page 243
Powering On the DC Powered PTX5000 Packet Transport Router with 120-A DC PDUs
and 120-A DC PSMs on page 245
Powering On the DC-Powered PTX5000 Packet Transport Router with High Capacity
DC PDUs and High Capacity DC PSMs on page 247
Powering On the Three-Phase AC-Powered PTX5000 Packet Transport Router on
page 249
Powering On the Single-Phase AC-Powered PTX5000 Packet Transport Router on
page 250
LED on the PDU faceplate is off. Verify that these additional
LED is off.
CB ON
SW ON LED is off.
Chapter 36: Powering Off the Router
CB ON
LED
499