PTX5000 Packet Transport Router Hardware Guide
Connecting Power to the PTX5000 High Capacity Delta AC PDUs
224
To connect an AC power cord to a High Capacity Delta AC PDU (see
Figure 120 on page
224):
Figure 120: High Capacity Delta AC PDU
1—
Top installation handle
2—
Front installation handle
3—
PDU OK
LED
4—
Power switch labeled (
|
) for the on position
and (
) for the standby position.
5—
Air exhaust ventilation
Switch off the customer-site circuit breakers. Ensure that the voltage across the AC
1.
power source is 0 V and that there is no chance that the voltage might become active
during installation.
Switch the power switch on the PDU faceplate to the standby ( ) position.
2.
Using a number 2 Phillips (+) screwdriver, remove the four screws from the metal
3.
retaining bracket located on the lower right of the PDU. Remove the metal retaining
bracket from the PDU (see
6—
Input voltage LED
7—
Wiring compartment
8—
Power input cord selection switch
9—
Metal retaining bracket
10—
Wiring compartment door
Figure 121 on page
225).
Copyright © 2017, Juniper Networks, Inc.