Figure 213: Connecting Grounding And Ac Power Wires To A Three-Phase Wye Ac Power Supply - Juniper PTX5000 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.
Connect the wires to the AC terminal block on the three-wye AC PDU
6.
(Figure 213 on page 339). Using a 1/5-in. (5.5-mm) slotted screwdriver, loosen each of
the input terminals or grounding point screws, insert each wire into the grounding
point or input terminal, and tighten the screw.
Insert the wire labeled
a.
Insert the wire labeled
b.
Insert the wire labeled
c.
Insert the wire labeled
d.
Insert the wire labeled
e.
Figure 213: Connecting Grounding and AC Power Wires to a Three-Phase
Wye AC Power Supply
Verify that the AC power and grounding wiring connections are correct.
7.
Using a number 2 Phillips (+) screwdriver, tighten the two captive screws on the metal
8.
AC wiring compartment.
Verify that the AC power cord is not touching or blocking access to packet transport
9.
router components, and that it does not drape where people could trip on it.
Reconnect the AC power cord to the power source.
10.
Chapter 27: Removing and Installing Power System Components
GND into the grounding point.
L1 into the L1 input terminal.
L2 into the L2 input terminal.
L3 into the L3 input terminal.
N into the N input terminal.
339