Copyright © 2017, Juniper Networks, Inc.
Figure 174: Removing a 120-A DC PDU
Place one hand underneath the PDU to support it and slide it partly out of the chassis
12.
until you can reach the two handles located on each side of the PDU.
Use the two handles on each side of the PDU to support it and slide the PDU
13.
completely out of the chassis.
WARNING:
Do not touch the power connectors on the rear of the PDU. They
can contain dangerous voltages.
CAUTION:
Each PDU weighs approximately 60 lb (27.2 kg). Be prepared to
support the full weight of the PDU as you remove it from the packet transport
router.
CAUTION:
Do not leave a PDU slot empty for more than a short time while
the packet transport router is operational. For proper airflow, the PDU must
remain in the chassis or a blank panel must be used in an empty slot.
Chapter 27: Removing and Installing Power System Components
297