Juniper PTX5000 Hardware Manual page 502

PTX5000 Packet Transport Router Hardware Guide
466
about installing a PIC, see the installation instructions in
on page 435.
Locate the slot in the FPC card cage in which you plan to install the FPC.
6.
Inspect the slot in the FPC card cage to verify that there are no missing or bent pins
7.
on the midplane.
Inspect the FPC to verify that the connectors are not misaligned or damaged.
8.
Orient the FPC vertically with the component side facing to the right. Be sure the FPC
9.
is right-side up, with the components on the right of the FPC.
CAUTION: When the FPC is out of the chassis, do not hold it by the ejector
handles, bus bars, or edge connectors. These components cannot support
its weight.
Carefully align the connector edge of the FPC with the appropriate empty slot in the
10.
chassis.
Lift the FPC into place and carefully align the bottom and top of the FPC with the
11.
guides inside the card cage.
"Replacing a PTX5000 PIC"
Copyright © 2017, Juniper Networks, Inc.