Installing a PTX5000 Three-Phase Delta AC PDU
Copyright © 2017, Juniper Networks, Inc.
Figure 190: Removing a Three-Phase Delta AC PDU
To install a three-phase delta AC PDU:
Ensure that the voltage across the AC power source is 0 V and that there is no chance
1.
that the voltage might become active during installation.
Switch the circuit breaker and the power
2.
the PDU to the off (
) position.
O
Grasp the front installation handle and top installation handle, and insert the PDU
3.
into the PDU slot.
Using both hands, slide the PDU into the chassis until you feel resistance.
4.
Chapter 27: Removing and Installing Power System Components
switch located on the faceplate of
OUTPUT
315