Holding PTX5000 FPCs Vertically
Copyright © 2017, Juniper Networks, Inc.
NOTE:
An FPC configured with PICs installed can weigh as much as
50 lb (22.7 kg). Be prepared to accept the full weight of the FPC as you lift it.
You hold an FPC vertically when installing it into the chassis. To hold an FPC vertically
(see
Figure 289 on page
489):
Orient the FPC so that the faceplate faces you.
1.
Place one hand around the FPC faceplate about a quarter of the way down from the
2.
top edge.
To avoid deforming the electromagnetic interference (EMI) shielding strip, do not
press hard on it.
Place your other hand at the bottom edge of the FPC.
3.
Figure 289: Holding an FPC Vertically
EMI shielding strip
Chapter 35: Maintaining Components
489