Installing a PTX5000 Horizontal Air Filter
Copyright © 2017, Juniper Networks, Inc.
Figure 147: Removing a Horizontal Air Filter
To install the horizontal air filter:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Locate markings on the side of the frame indicating airflow direction.
2.
Position the air filter over the air filter tray. Note the correct orientation for airflow
3.
direction. The airflow direction is through the perforated faceplate and up through
the filter.
Engage the edge nearest the perforated faceplate under the front flange, and slide
4.
the filter further toward the faceplate.
Engage the opposite filter edge under the retainer bracket at the rear of the air filter
tray and snap the air filter into place (see
Reinstall the horizontal air filter tray into chassis (see
5.
Tighten captive screws to secure the air filter tray.
6.
Chapter 26: Removing and Installing Cooling System Components
Figure 148 on page
Figure 149 on page
272).
272).
271