Replacing a PTX5000 Power Supply Module Air Filter
Removing a PTX5000 Power Supply Module Air Filter
Installing a PTX5000 Power Supply Module Air Filter
Copyright © 2017, Juniper Networks, Inc.
Removing a PTX5000 Power Supply Module Air Filter on page 279
1.
Installing a PTX5000 Power Supply Module Air Filter on page 279
2.
The PSM air filter is located inside the PSM door.
To remove the PSM air filter (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Loosen the captive screws on the PSM door, and open the door.
2.
Inside the PSM door, locate the air filter retaining bracket at the top of the door. Using
3.
a number 2 Phillips (+) screwdriver, remove the 2 screws from the air filter retaining
bracket, and remove the bracket.
Remove the air filter.
4.
Discard the air filter.
5.
Figure 156: Removing a PSM Door Air Filter
1—
Air filter retaining bracket
To install the PSM air filter (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Locate markings on the side of the frame indicating airflow direction.
2.
Chapter 26: Removing and Installing Cooling System Components
Figure 156 on page
279):
1
2
2—
Air filter
Figure 157 on page
280):
279