Removing A Compactflash Card From A T4000 Re-C1800 Routing; Engine; Installing A Compactflash Card Into A T4000 Re-C1800 Routing Engine; Figure 128: Removing A Compactflash Card - Juniper T4000 Hardware Manual

Removing a CompactFlash Card from a T4000 RE-C1800 Routing Engine

Installing a CompactFlash Card into a T4000 RE-C1800 Routing Engine

Copyright © 2013, Juniper Networks, Inc.
The CompactFlash card is located in the slot labeled
To remove the CompactFlash card (see
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Verify that the ,
Online DISK1
2.
are off.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
3.
the strap to one of the ESD points on the chassis.
Using a Phillips (+) screwdriver, number 2, loosen the captive screws on the corners
4.
of the cover over the Routing Engine slots.
Remove the cover from the Routing Engine slots.
5.
CAUTION: Do not remove the cover if any of the LEDs are lit.
Press the eject button on the right side of the CompactFlash card slot to release the
6.
CompactFlash card.
The CompactFlash card pops partially out of the slot. Grasp the card and pull it
7.
completely out of the slot.
Place the CompactFlash card on the antistatic mat.
8.

Figure 128: Removing a CompactFlash Card

To install a CompactFlash card (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Insert the CompactFlash card into the CompactFlash card slot on the Routing Engine,
2.
with the logo facing up.
CAUTION: Be sure to insert the CompactFlash card with the label facing
up. Inserting the CompactFlash card incorrectly might damage the Routing

Engine.

Chapter 19: Replacing T4000 Router Hardware Components
CF on the Routing Engine faceplate.
Figure 128 on page
, and LEDs on the backup Routing Engine faceplate
CF
Figure 129 on page 272):
271):
271