Figure 209: Disconnecting Ac Power Wires From A Three-Phase Wye Ac Power - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide
336
Disconnect the wires from the AC terminal block on the three-phase delta AC power
7.
supply (Figure 209 on page
the input terminal or grounding point screw, and remove each wire from the input
terminal or grounding point.
Remove the wire labeled
a.
Remove the wire labeled
b.
Remove the wire labeled
c.
Remove the wire labeled
d.
Remove the wire labeled
e.
Figure 209: Disconnecting AC Power Wires from a Three-Phase Wye AC
Power Supply
Using a number 2 Phillips (+) screwdriver, loosen the captive screws that secure the
8.
metal retaining bracket and AC power cord to the PDU. While gently removing the
wires of the AC power cord from the wiring compartment, remove the metal retaining
bracket and AC power cord from the PDU. See
336). Using a 1/5-in. (5.5-mm) slotted screwdriver, loosen
N from the N input terminal.
L3 from the L3 input terminal.
L2 from the L2 input terminal.
L1 from the L1 input terminal.
GND into the grounding point.
Figure 210 on page
Copyright © 2017, Juniper Networks, Inc.
337.