Figure 244: Applying New Psm Slot Label - Juniper PTX5000 Hardware Manual

Packet transport router

Hide thumbs Also See for PTX5000:

Table of Contents

PTX5000 Packet Transport Router Hardware Guide

Documentation

Fasten the sleeve bracket screws into the chassis by using a number 1 Phillips (+)

screwdriver.

Remove the old PSM slot label. You can lift a corner and peel off the label.

Remove the sticker liner from the new PSM slot label and apply it to the chassis,

centered over the screws.

Figure 244: Applying New PSM Slot Label

Repeat these steps for the other sleeve assemblies.

Replacing a PTX5000 High Capacity DC PSM on page 308

Table of Contents