Figure 205: Removing The Metal Retaining Bracket From The Three-Phase Wye; Figure 206: Connecting The Metal Retaining Bracket And Ac Power Cord To The - Juniper PTX5000 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.
Using a number 2 Phillips (+) screwdriver, loosen the four captive screws on the metal
6.
retaining bracket located on the lower right of the newly installed PDU. Remove the
metal retaining bracket from the PDU.
Figure 205: Removing the Metal Retaining Bracket from the Three-Phase
Wye PDU
Using a number 2 Phillips (+) screwdriver, loosen the two captive screws on the metal
7.
AC wiring compartment of the replacement PDU. Open the metal door of the metal
AC wiring compartment.
Gently push the wires of the AC power cord into the area for the metal retaining bracket,
8.
and pull the wires to the left toward the metal AC wiring compartment.
Using a number 2 Phillips (+) screwdriver, tighten the four captive screws on the metal
9.
retaining bracket to secure the AC power cord to the PDU.
Figure 206: Connecting the Metal Retaining Bracket and AC Power Cord
to the Three-Phase Wye PDU
Chapter 27: Removing and Installing Power System Components
331