Figure 192: Connecting Grounding And Ac Power Wires To A Three-Phase Delta - Juniper PTX5000 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.
Connect the wires to the AC terminal block on the three-phase delta AC PDU
9.
(Figure 192 on page 317). Using a 1/5-in. (5.5-mm) slotted screwdriver, loosen the input
terminal or grounding point screw, insert each wire into the grounding point or input
terminal, and tighten the screw.
Insert the wire labeled
a.
Insert the wire labeled
b.
Insert the wire labeled
c.
Insert the wire labeled
d.
Figure 192: Connecting Grounding and AC Power Wires to a Three-Phase
Delta AC Power Supply
Verify that the AC power and grounding wiring connections are correct.
10.
Using a number 2 Phillips (+) screwdriver, tighten the two captive screws on the metal
11.
AC wiring compartment.
Verify that the AC power cord is not touching or blocking access to packet transport
12.
router components, and that it does not drape where people could trip on it.
Reconnect the AC power cord to the power source.
13.
NOTE: After powering on a PDU, you must wait at least 60 seconds before
turning it off.
Chapter 27: Removing and Installing Power System Components
GND into the grounding point.
L1 into the L1 input terminal.
L2 into the L2 input terminal.
L3 into the L3 input terminal.
317