Copyright © 2017, Juniper Networks, Inc.
Remove the power supply modules (PSMs) in the front of the chassis from the PDU
5.
to be removed (see
Figure 186 on page
Loosen the captive screws on the door covering the PSMs and open the door.
a.
Loosen the captive screw on the PSM ejector handle.
b.
Grasp the ejector handle and pull to eject the PSM.
c.
Slide the PSM halfway out of the chassis. Place one hand underneath the PSM to
d.
support it and slide it completely out of the chassis.
Repeat these steps for the remaining PSMs in the PDU.
e.
Figure 186: Removing the AC Power Supply Modules
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
6.
the strap to one of the ESD points on the chassis at the back of the packet transport
router.
Open the door of the metal wiring compartment.
7.
Chapter 27: Removing and Installing Power System Components
311).
311