Verifying The Upgrade And Configuring The Upgraded Routing Engine; Figure 270: Installing The Re-Ptx-X8-64G Routing Engine - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Verifying the Upgrade and Configuring the Upgraded Routing Engine

422
Carefully align the sides of the Routing Engine with the guides inside the opening on
4.
the Control Board.
Slide the Routing Engine into the chassis until you feel resistance, then press the
5.
Routing Engine's faceplate until it engages the connectors.
Press both the ejector handles inward to seat the Routing Engine.
6.
The Routing Engine might require several minutes to boot. If the packet transport router
is powered on and the Routing Engine's corresponding Control Board is functioning
normally, the Routing Engine comes online automatically.

Figure 270: Installing the RE-PTX-X8-64G Routing Engine

Verify that the Routing Engine is installed correctly and functioning properly:
Verify that the green ONLINE
1.
Verify the status of the Routing Engine by using the
2.
command.
The Routing Engine might require several minutes to boot. After the Routing Engine
boots, verify that it is installed correctly by checking
craft interface. If the router is operational and the Routing Engine is functioning properly,
the green LED lights steadily. If the red
ONLINE
and reinstall the Routing Engine. If the red
Engine is not functioning properly. Contact your customer support representative.
NOTE: To maintain proper airflow through the chassis, do not leave a CB
installed in the chassis without a Routing Engine for extended periods of
time. If a Routing Engine is removed, a replacement Routing Engine should
be installed as soon as possible.
LED lights steadily.
show chassis routing-engine
FAIL
LED lights steadily instead, remove
FAIL
LED still lights steadily, the Routing
FAIL
Copyright © 2017, Juniper Networks, Inc.
, RE0 , and RE1 LEDs on the