Copyright © 2017, Juniper Networks, Inc.
Figure 86: Installing Brackets on the Front-Mounting Flanges
Partially install the remaining screws, and attach the side panels to the front mounting
3.
flanges. Use the cutouts in the side panel mounting holes to slide the panel behind
the partially installed screws
Attach the door to the side panels by placing the door on the hinges. Ensure that the
4.
door opens and closes properly, and the captive screws on the door align correctly
with the holes in the side panels.
NOTE:
If the door is not aligned properly, loosen the screws securing the
side panels to the front-mounting flanges, and adjust the panels until the
door closes correctly, then tighten the screws completely using the
screwdriver.
Chapter 18: Installing the Front Door on the Router
(seeFigure 87 on page
184). Tighten the screws completely.
183