CHAPTER 31
Removing and Installing Switch Fabric
Components
Replacing a PTX5000 Switch Interface Board
Removing a PTX5000 Switch Interface Board
Copyright © 2017, Juniper Networks, Inc.
Replacing a PTX5000 Switch Interface Board on page 425
Removing a PTX5000 Switch Interface Board on page 425
1.
Installing a PTX5000 Switch Interface Board on page 426
2.
Nine SIBs are installed in the packet transport router. The SIBs are located in the rear of
the chassis in the slots marked
10.4 lb (4.7 kg).
To remove the SIBs (see
Figure 271 on page
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Twist the ejector handles counterclockwise to unseat the SIB.
3.
Grasp both ejector handles, pull firmly, and slide the SIB about three-quarters of the
4.
way out of the chassis.
Place one hand underneath the SIB to support it and slide it completely out of the
5.
chassis. Place it on the antistatic mat.
CAUTION:
Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
through
. Each SIB can weigh up to
SIB0
SIB8
426):
425