Holding Ptx5000 Fpcs; Preventing Damage To Fpcs - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide
Related
Documentation

Holding PTX5000 FPCs

Preventing Damage to FPCs

486
Issue the CLI
show chassis environment fpc
power of installed FPCs. The temperature values should be below the preconfigured
thresholds. The power values provide Information about the voltage supplied to the
FPC. The left column displays the required power, in volts. The right column displays
the measured power, in millivolts.
Issue the show chassis fabric topology
for the command shows that the state of the online SIBs and FPCs links are in the
state.
PTX5000 FPC Description on page 95
Troubleshooting the PTX5000 FPCs on page 526
Preventing Damage to FPCs on page 486
Holding PTX5000 FPCs Vertically on page 489
Holding PTX5000 FPCs Horizontally on page 490
CAUTION: Many components on the FPC are fragile. Failure to handle FPCs
as specified in this document can cause irreparable damage.
CAUTION: To prevent damage when handling or carrying FPCs:
As you carry the FPC, do not bump it against anything. FPC components
are fragile.
Do not grasp the FPC anywhere except places that this document indicates.
In particular, never grasp the connector edge, especially at the power
connector in the corner where the connector and bottom edges meet (see
Figure 286 on page
Do not carry the FPC by the faceplate with only one hand (see
Figure 287 on page
Do not rest any edge of an FPC directly against a hard surface (see
Figure 288 on page
while changing its orientation between vertical and horizontal, use your
hand as a cushion between the edge and the surface.
command to check the temperature and
command. During normal operations, the output
487).
488).
488). If you must rest the FPC temporarily on an edge
Copyright © 2017, Juniper Networks, Inc.
OK