Figure 129: High Capacity Wye Ac Pdu - Juniper PTX5000 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.

Figure 129: High Capacity Wye AC PDU

1— Top Installation handle
2— Front installation handle
3— PDU OK
LED
4— |
Power switch labeled ( ) for the on position
and ( ) for the standby position.
5— Air exhaust ventilation
To connect an AC power cord to a High Capacity Wye AC PDU (see
Switch off the customer-site circuit breakers. Ensure that the voltage across the AC
1.
power source is 0 V and that there is no chance that the voltage might become active
during installation.
Move the circuit breaker on the faceplate of the PDU to the off position.
2.
Move the power switch located on the faceplate of the PDU to the standby ( )
3.
position.
Using a number 2 Phillips (+) screwdriver, loosen the four captive screws that fasten
4.
the metal retaining bracket to the PDU, and remove the metal retaining bracket from
the PDU (see Figure 130 on page
Chapter 21: Connecting the Router to Power
6— Circuit breaker
7— Input voltage LED
8— Wiring compartment
9— Metal retaining bracket
10— Wiring compartment door
232).
Figure 129 on page 231):
231