Figure 106: Removing The Retaining Nut From A Three-Phase Delta Ac Power; Figure 107: Connecting The Metal Retaining Bracket To Three-Phase Delta Ac - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide
212
Figure 106: Removing the Retaining Nut from a Three-Phase Delta AC
Power Cord
1 1
1— Retaining nut
Put the wires of the AC power cord through the hole of the metal retaining bracket,
5.
and screw the retaining nut onto the AC power cord to secure it to the metal retaining
bracket (see Figure 107 on page
Figure 107: Connecting the Metal Retaining Bracket to Three-Phase Delta
AC Power Cord
1 1
2
1— Retaining nut
2—Metal retaining bracket
Using a number 2 Phillips (+) screwdriver, loosen the two captive screws on the metal
6.
AC wiring compartment. Open the metal door of the metal AC wiring compartment.
Push the wires of the AC power cord into the area for the metal retaining bracket, and
pull the wires to the left toward the metal AC wiring compartment. Using a number
2 Phillips (+) screwdriver, use the four screws on the metal retaining bracket to secure
the AC power cord to the PDU (see
2
2— Three-phase delta AC power cord
212).
3
3— Three-phase delta AC power cord
Figure 108 on page 213).
Copyright © 2017, Juniper Networks, Inc.