Router - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide
Related
Documentation
Powering On the Single-Phase AC-Powered PTX5000 Packet Transport Router
250
Move the power switch on the PDU to the on (
8. OUTPUT
Verify that the
9. PDU OK
PDU is correctly installed and is functioning properly.
NOTE: If the
and cabling procedures.
Repeat steps 6 through 9 for the other PDU.
10.
Check the LEDs on the PSMs. For each PSM, verify that the
11.
LEDs are lit steadily green, and that the
NOTE: If the
LED is lit, see
FAULT
page 535 in the
On the external management device connected to the Routing Engine, monitor the
12.
startup process to verify that the system has booted properly.
PTX5000 Power Distribution Unit LEDs on page 56
PTX5000 Power Supply Module LEDs on page 66
To power on the AC-powered PTX5000 with high-capacity single-phase AC PDUs, and
with AC PSMs:
NOTE: After powering off a PDU, you must wait at least 60 seconds before
powering it on again.
Verify that the PDUs and PSMs are fully inserted in the chassis and that the captive
1.
screws on the faceplates are tightened.
Verify that an external management device is connected to one of the Routing Engine
2.
ports on the Control Board (
LED on the PDU faceplate is lit steadily, indicating that the
PDU OK LED does not light steadily, repeat the installation
LED is off.
Fault
and LEDs do not light steadily or if the
Input OK Output OK
"Troubleshooting the PTX5000 Power System" on
PTX5000 Packet Transport Router Hardware Guide
AUXILIARY or CONSOLE
) position.
|
and
AC IN OK DC IN OK
.
).
Copyright © 2017, Juniper Networks, Inc.