Unpacking The Ptx5000 Packet Transport Router - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide
Related
Documentation

Unpacking the PTX5000 Packet Transport Router

160
Overview of Unpacking the PTX5000 Packet Transport Router on page 159
Unpacking the PTX5000 Packet Transport Router on page 160
The PTX5000 is shipped in a wooden crate. A wooden pallet forms the base of the crate.
The chassis is bolted to this pallet. Quick Start installation instructions and a cardboard
accessory box are also included in the shipping crate.
The shipping crate measures:
73.3 in (186.2 cm)high
33.0 in (83.8 cm) wide
51.5 in (130.9 cm) deep
The total weight of the crate containing the packet transport router and accessories can
range up to 1,300 lb (589.7 kg).
NOTE: The PTX5000 is maximally protected inside the shipping crate. Do
not unpack it until you are ready to begin installation.
To unpack the PTX5000 (see
Move the shipping crate to a staging area as close to the installation site as possible,
1.
where you have enough room to remove the components from the chassis. While the
chassis is bolted to the pallet, you can use a forklift or pallet jack to move it.
Position the shipping crate with the arrows pointing up.
2.
Open all the latches on the shipping crate.
3.
Remove the front door of the shipping crate cover and set it aside.
4.
Slide the remainder of the shipping crate cover off the pallet.
5.
Remove the foam covering the top of the PTX5000.
6.
Remove the accessory box and the Quick Start documentation.
7.
Verify the parts received against the lists in
8.
Router Parts Received" on page
Figure 78 on page 161):
"Verifying the PTX5000 Packet Transport
162.
Copyright © 2017, Juniper Networks, Inc.