Removing A Ptx5000 Pic Cfp Transceiver - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Removing a PTX5000 PIC CFP Transceiver

442
C form-factor pluggables (CFPs) are transceivers that can be removed from a PIC. CFP
transceivers are hot-insertable and hot-removable. Removing a CFP transceiver does
not interrupt PIC functioning, but the removed CFP transceiver no longer receives or
transmits data.
To remove a CFP transceiver:
Place an electrostatic bag or antistatic mat on a flat, stable surface to receive the
1.
CFP transceiver. Have ready a rubber safety cap for the CFP transceiver and the cable.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Label the cable connected to the CFP transceiver so that you can later reconnect it
3.
to the correct CFP transceiver.
Disconnect the cable from the CFP transceiver. Immediately cover the transceiver
4.
and the end of the cable with a rubber safety cap.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing cable. The safety cap keeps the port clean and
prevents accidental exposure to laser light.
Arrange the cable in the cable management system to prevent it from dislodging or
5.
developing stress points. Secure the cable so that it is not supporting its own weight
as it hangs to the floor. Place excess cable out of the way in a neatly coiled loop in
the cable management system. Placing fasteners on the loop helps to maintain its
shape.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
Pull the ejector handle away from the CFP transceiver faceplate to unseat the CFP
6.
transceiver from the PIC. Pull the CFP transceiver out of the PIC and place it on the
antistatic mat or in the electrostatic bag.
Copyright © 2017, Juniper Networks, Inc.