Installing A Ptx5000 Pic Cfp Transceiver - Juniper PTX5000 Hardware Manual

Installing a PTX5000 PIC CFP Transceiver

Copyright © 2017, Juniper Networks, Inc.
To install a replacement CFP:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Verify that a rubber safety cap covers the CFP transceiver, installing one if necessary.
2.
Orient the CFP over the port in the PIC so that the connector end will enter the slot
3.
first and the CFP connector faces the appropriate direction.
Slide the CFP into the slot. If there is resistance, remove the CFP and flip it so that the
4.
connector faces the other direction.
Remove the rubber safety cap from the transceiver and the end of the cable, and
5.
insert the cable into the transceiver.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing cable. The safety cap keeps the port clean and
prevents accidental exposure to laser light.
Arrange the cable in the cable management system to prevent the cable from
6.
dislodging or developing stress points. Secure the cable so that it is not supporting its
own weight as it hangs to the floor. Place excess cable out of the way in a neatly coiled
loop in the cable management system. Placing fasteners on the loop helps to maintain
its shape.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do
not allow fastened loops of cable to dangle, which stresses the cable at
the fastening point.
Chapter 32: Removing and Installing Interface Module Components
443