Removing the Control Board
Copyright © 2017, Juniper Networks, Inc.
Figure 267: Removing the RE-PTX-X8-64G Routing Engine
To remove a Control Board (see
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the
2.
ESD points on the chassis.
Label and disconnect the cables.
3.
Rotate the ejector handles counterclockwise on both sides of the Control Board
4.
faceplate.
Grasp the ejector handles and slide the Control Board about halfway out of the chassis.
5.
Place one hand underneath the Control Board to support it and slide it completely
6.
out of the chassis. Place it on the antistatic mat.
CAUTION:
Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
Chapter 30: Upgrading to RE-PTX-X8-64G Routing Engines
Figure 268 on page
420):
419