Figure 225: Removing The Metal Retaining Bracket And Ac Power Cord - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide
354

Figure 225: Removing the Metal Retaining Bracket and AC Power Cord

Loosen the four captive screws attaching the front PDU handle to the PDU and chassis.
9.
Grasp the front installation handle on the PDU faceplate and pull the handle firmly
10.
down toward you. Slide the PDU halfway out of the chassis until you can reach the
top installation handle. (See
Use the top and front installation handle to slide the PDU completely out of the chassis.
11.
CAUTION: Each PDU weighs approximately 63.3 lb (28.7 kg). Be prepared
to support the full weight of the PDU as you remove it from the packet
transport router.
WARNING: Do not touch the power connectors on the rear of the PDU. They
can contain dangerous voltages.
CAUTION: Do not leave a PDU slot empty for more than a short time while
the packet transport router is operational. For proper airflow, the PDU must
remain in the chassis or a blank panel must be used in an empty slot.
Figure 226 on page 355.)
Copyright © 2017, Juniper Networks, Inc.