PTX5000 Packet Transport Router Hardware Guide
Installing the Routing Engine RE-PTX-X8-64G
416
NOTE:
While installing, ensure that you install the Control Board that is
compatible with the Routing Engine. Install the Routing Engine
RE-DUO-C2600-16G into the Control Board CB-PTX and Routing Engine
RE-PTX-X8-64G into the Control Board CB2-PTX only.
Figure 266: Installing the RE-PTX-X8-64G Routing Engine
To install a Routing Engine (see
Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the
1.
ESD points on the chassis.
Ensure that the ejector handles are not in the locked position. If necessary, press the
2.
red tabs and flip the ejector handles outward.
Place one hand underneath the Routing Engine to support it. With the other hand,
3.
grasp one of the ejector handles on the faceplate.
Carefully align the sides of the Routing Engine with the guides inside the opening on
4.
the Control Board.
Slide the Routing Engine into the chassis until you feel resistance, and then press the
5.
Routing Engine's faceplate until it engages the connectors.
Press both the ejector handles inward to seat the Routing Engine.
6.
The Routing Engine might require several minutes to boot. If the packet transport
router is powered on and the Routing Engine's corresponding Control Board is
functioning normally, the Routing Engine comes online automatically.
Reconnect the cables.
7.
The Routing Engine RE1 comes up as the backup Routing Engine.
8.
Figure 266 on page
416):
Copyright © 2017, Juniper Networks, Inc.