Figure 254: Removing The Ssd Drive From A Re-Ptx-X8-64G - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide
400
To replace a SSD drive:
Offline the Routing Engine by pressing the
1.
Remove the SSD drive.
2.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
a.
connect the strap to an ESD point on the appliance.
For more information about ESD, see Preventing Electrostatic Discharge Damage
in the hardware guide for your router.
Unfasten the thumbscrew that secures the access door in front of the storage drive
b.
slots, and open the door.
Slide the lock on the ejector to the unlocked position.
c.
Carefully slide the drive out of the slot.
d.

Figure 254: Removing the SSD Drive From a RE-PTX-X8-64G

Reinstall a storage drive.
3.
Carefully align the sides of the drive with the guides in the slot.
a.
Slide the drive into the slot until you feel resistance, carefully ensuring that it is
b.
correctly aligned.
Close the access door and tighten the thumbscrew to secure the door.
c.
Bring the Routing Engine online by pressing the
4.
CLI by using
request chassis cb0/1 online
Verify that the SSD drive is recognized by using the
5.
button.
ONLINE/OFFLINE
ONLINE/OFFLINE button or from the
command.
show vmhost hardward
Copyright © 2017, Juniper Networks, Inc.
command.