Figure 222: Connecting Grounding And Ac Power Wires To A High Capacity Delta Ac Power Supply - Juniper PTX5000 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.
Connect the wires to the AC terminal block on the High Capacity Delta AC PDU
10.
(Figure 222 on page 349). Using a 1/5-in. (5.5-mm) slotted screwdriver, loosen the input
terminal screws and the grounding point screw, insert each wire into the grounding
point or input terminal, and tighten the screws.
Insert the wire labeled
a.
Insert the wire labeled
b.
Insert the wire labeled
c.
Insert the wire labeled
d.
Figure 222: Connecting Grounding and AC Power Wires to a High Capacity
Delta AC Power Supply
Verify that the AC power and grounding wiring connections are correct.
11.
Using a number 2 Phillips (+) screwdriver, tighten the two captive screws on the metal
12.
AC wiring compartment.
Verify that the AC power cord does not touch or block access to chassis components,
13.
and that it does not drape where people could trip on it.
Reconnect the AC power cord to the power source.
14.
Chapter 27: Removing and Installing Power System Components
GND into the grounding point.
L1 into the L1 input terminal.
L2 into the L2 input terminal.
L3 into the L3 input terminal.
349