Figure 123: Removing The Retaining Nut From An Ac Power Cord; Figure 124: Connecting The Metal Retaining Bracket To An Ac Power Cord - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide
226

Figure 123: Removing the Retaining Nut from an AC Power Cord

1 1
1— Retaining nut
Put the wires of the AC power cord through the hole of the metal retaining bracket,
5.
and screw the retaining nut onto the AC power cord to secure it to the metal retaining
bracket (see Figure 124 on page

Figure 124: Connecting the Metal Retaining Bracket to an AC Power Cord

NOTE: If you are using 150 A power, you must use a metal bracket that is
larger than the default metal bracket. This bracket is shipped along with
the High Capacity Delta AC PDUs. Labels on top of the metal brackets
specify the power cords that can be used for each bracket (see
Figure 125 on page
bracket to the PDU is the same for both metal brackets.
2
2— AC power cord
226).
227). The installation procedure to connect the metal
Copyright © 2017, Juniper Networks, Inc.