Figure 280: Removing A Sib From The Ptx5000; Figure 281: Installing A Sib Into The Ptx5000 - Juniper PTX5000 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.
Remove the offline SIB:
10.
Twist the ejector handles counterclockwise to unseat the SIB.
a.
Grasp both ejector handles, pull firmly, and slide the SIB about three-quarters of
b.
the way out of the chassis.

Figure 280: Removing a SIB from the PTX5000

Place one hand underneath the SIB to support it and slide it completely out of the
c.
chassis. Place it on the antistatic mat.
CAUTION:
you remove them. Place each component on an antistatic mat resting
on a stable, flat surface.
Install the new SIB:
11.

Figure 281: Installing a SIB into the PTX5000

Do not stack hardware components on one another after
Chapter 33: Upgrading FPCs
461