Removing A Ptx Series Pic Air Filter; Figure 154: Removing A Pic Air Filter - Juniper PTX5000 Hardware Manual

Removing a PTX Series PIC Air Filter

Copyright © 2017, Juniper Networks, Inc.
The 10-port 10-Gigabit Ethernet/40-Gigabit Ethernet/100-Gigabit Ethernet PIC with
QSFP28 (P3-10-U-QSFP28) has air vents on the PIC faceplate, and has a field-replaceable
air filter cover over the air vents.
To remove the PIC air filter (see
To prevent damage to the equipment caused by static discharge, attach an
1.
electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the
strap to one of the ESD points on the chassis.
Loosen the thumbscrews that secure the air filter cover to the PIC faceplate.
2.
Pull to remove the air filter cover and air filter.
3.
Remove the air filter from the air filter cover.
4.
Discard the air filter.
5.

Figure 154: Removing a PIC Air Filter

1— Air filter cover
2—Air filter
Chapter 26: Removing and Installing Cooling System Components
Figure 154 on page 277):
3— Air vent
277