Figure 182: Removing A High Capacity Dc Pdu - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide
306

Figure 182: Removing a High Capacity DC PDU

-48V/60 A
Place one hand underneath the PDU to support it and slide it partly out of the chassis
9.
until you can reach the two handles located on each side of the PDU.
Use the two handles on each side of the PDU to support it and slide the PDU
10.
completely out of the chassis.
WARNING: Do not touch the power connectors on the rear of the PDU. They
can contain dangerous voltages.
CAUTION: Each PDU weighs approximately 64.5 lb (29.3 kg). Be prepared
to support the full weight of the PDU as you remove it from the packet
transport router.
CAUTION: Do not leave a PDU slot empty for more than a short time while
the packet transport router is operational. For proper airflow, the PDU must
remain in the chassis or a blank panel must be used in an empty slot.
Copyright © 2017, Juniper Networks, Inc.