Figure 217: Disconnecting Ac Power Wires From A High Capacity Delta Ac - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide
344
Disconnect the wires from the AC terminal block on the High Capacity Delta AC PDU
8.
(Figure 217 on page 344). Using a 5/16-in. (8-mm) slotted screwdriver, loosen the input
terminal screws and the grounding point screw, and remove each wire from the input
terminal and the grounding point.
Remove the wire labeled
a.
Remove the wire labeled
b.
Remove the wire labeled
c.
Remove the wire labeled
d.

Figure 217: Disconnecting AC Power Wires from a High Capacity Delta AC

PDU
Using a number 2 Phillips (+) screwdriver, loosen the captive screws that secure the
9.
metal retaining bracket and AC power cord to the PDU. While gently removing the
wires of the AC power cord from the wiring compartment, remove the metal retaining
bracket and AC power cord from the PDU. See
L3 from the L3 input terminal.
L2 from the L2 input terminal.
L1 from the L1 input terminal.
GND from the grounding point.
Figure 218 on page
Copyright © 2017, Juniper Networks, Inc.
345.