Rj-45 Connector Pinouts For The Ptx5000 Auxiliary And Console Ports; Port; Table 71: Rj-45 Connector Pinouts For The Ptx5000 Auxiliary And Console - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide
Related
Documentation

RJ-45 Connector Pinouts for the PTX5000 Auxiliary and Console Ports

Table 71: RJ-45 Connector Pinouts for the PTX5000 Auxiliary and Console Ports
Pin Signal
1 RTS Output
2 DTR Output
3 TxD Output
4 Signal Ground
5 Signal Ground
6 RxD Input
7 CD Input
150
Table 70: Cable Specifications for Routing Engine
Management (continued)

Port

Cable Specification
Routing Engine Category 5 cable or
Host/Ethernet equivalent suitable for
interface 10/100-Mbps/1-Gbps
operation
(X) GE0 through Ports are reserved for
interfaces future use.
(X) GE0
interface Port is reserved for
GE4
future use.
PTX5000 Control Board Description on page 83
Connecting the PTX5000 Packet Transport Router to a Management Console or
Auxiliary Device on page 188
Connecting the PTX5000 Packet Transport Router to a Management Ethernet Device
on page 189
The auxiliary and console ports on the Control Board (labeled
are RJ-45 receptacles that accept RS-232 (EIA-232) cable. The
the Routing Engine to a laptop, modem, or other auxiliary unit, and the
connects it to a management console. The ports are configured as data terminal
equipment (DTE). Table 71 on page 150
Maximum
Cable Supplied Length
One 15-ft 328 ft (100
(4.57-m) length m)
with RJ-45/RJ-45
connectors
None 328 ft (100
m)
None 328 ft (100
m)
AUXILIARY
AUXILIARY
describes the RJ-45 connector pinouts.
Description
Request to send
Data terminal ready
Transmit data
Signal ground
Signal ground
Receive data
Data carrier detect
Copyright © 2017, Juniper Networks, Inc.
Packet
Transport
Router
Receptacle
RJ-45
SFP+
SFP
and )
CONSOLE
port connects
port
CONSOLE