Installing The Four-Post Mounting Shelf And Rear Support Bracket - Juniper PTX5000 Hardware Manual

Installing the Four-Post Mounting Shelf and Rear Support Bracket

Copyright © 2017, Juniper Networks, Inc.
To install the four-post mounting shelf and rear support bracket (see
Figure 79 on page 168):
On the rear of each rear rack rail, partially insert a mounting screw into the lowest hole
1.
specified in Table 75 on page
Install the rear support bracket on the rear of the rear rack rails. Rest the bottom slot
2.
of the rear support bracket on a mounting screw. The rear support bracket extends
toward the center of the rack.
Partially insert screws into the open holes in the rear support bracket.
3.
Tighten all the screws completely.
4.
On the front of each front rack rail, partially insert a mounting screw into the lowest
5.
hole specified in Table 75 on page
Install the four-post rack mounting shelf on the front rack rails. Rest the bottom slot
6.
of the front flange on a mounting screw. Rest the back of the four-post rack mounting
shelf on top of the rear support bracket.
Partially insert screws into the open holes in the mounting shelf.
7.
Tighten all the screws completely.
8.
Fasten the four-post mounting shelf to the rear support bracket by partially inserting
9.
the screws provided in the accessory kit into the open holes on top of the four-post
mounting shelf.
NOTE: Several holes are provided on top of the shelf. Two holes on each
side of the shelf will align with the holes in the rear support bracket.
Tighten all the screws completely.
10.
Chapter 16: Installing the Mounting Hardware
165.
165.
167