Installing The Routing Engine Re-Ptx-X8-64G; Figure 248: Installing The Re-Ptx-X8-64G Routing Engine - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Installing the Routing Engine RE-PTX-X8-64G

392

Figure 248: Installing the RE-PTX-X8-64G Routing Engine

NOTE: While installing, ensure that you install the Routing Engine
RE-PTX-X8-64G into the Control Board CB2-PTX only.
To install a Routing Engine (see
Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the
1.
ESD points on the chassis.
Ensure that the ejector handles are not in the locked position. If necessary, press the
2.
red tabs and flip the ejector handles outward.
Place one hand underneath the Routing Engine to support it. With the other hand,
3.
grasp one of the ejector handles on the faceplate.
Carefully align the sides of the Routing Engine with the guides inside the opening on
4.
the Control Board.
Slide the Routing Engine into the chassis until you feel resistance, and then press the
5.
Routing Engine's faceplate until it engages the connectors.
Press both the ejector handles inward to seat the Routing Engine.
6.
Reconnect the cables and verify that the Routing Engine is installed correctly and
7.
functioning properly:
Verify that the green
Verify the status of the Routing Engine using the
command.
The Routing Engine might require several minutes to boot. If the packet transport
router is powered on and the Routing Engine's corresponding Control Board is
functioning normally, the Routing Engine comes online automatically.
Figure 248 on page 392):
LED lights steadily.
ONLINE
show chassis routing-engine
Copyright © 2017, Juniper Networks, Inc.