Verifying The Replaced Sibs; Upgrading The Fpcs - Juniper PTX5000 Hardware Manual

Verifying the Replaced SIBs

Upgrading the FPCs

Copyright © 2017, Juniper Networks, Inc.
Bring the SIB online by using one of the following methods:
1.
Press and hold the ONLINE/OFFLINE
LED on the faceplate begins to blink. Hold the button down until the LED blinks.
Issue the following CLI command on the packet transport router:
user@host> request chassis sib online slot slot number
To verify that all the new SIBs are installed, use the
2.
The new SIBs ID should be displayed in the command output (see
Component Overview" on page
To verify the status of the SIBs:
Issue the show chassis fabric errors
the link status for each SIB.
Also use the
show chassis fabric sibs
SIB.
Issue the
show chassis fabric fpcs
whether any fabric error is logged.
Use the
show chassis fabric topology
Packet Forwarding Engines.
If there are any errors in the replaced SIB, debug the errors. See
3.
PTX5000 Switch Interface Boards" on page
If all the replaced SIBs are functioning correctly, issue the
4.
to exit the upgrade mode.
upgrade-mode default
Before you begin upgrading the FPCs, use the
the following:
That the correct SIBs are installed.
That the correct PDU and PSM are installed.
That the correct fan tray is installed.
To determine which hardware is required for the FPC that you are upgrading to, see
"PTX5000 FPC Upgrade Kit" on page
To upgrade the FPCs:
Verify that all the SIBs on the PTX5000 packet transport router are correct, by using
1.
the show chassis hardware
button on the SIB faceplate. The green
show chassis hardware
5).
command at the
command to check the link status for each
command at the
to check the link status of all the SIBs and
548.
show chassis hardware
456.
command.
Chapter 33: Upgrading FPCs
OK
command.
"PTX5000 Hardware
[edit] hierarchy level to verify
hierarchy level to check
[edit]
"Troubleshooting the
delete chassis fabric
command to verify
475