Advertisement
OCX1100 Switch Hardware Guide
Related
Documentation
Connecting DC Power to an OCX1100 Switch
82
Figure 26: Connecting an AC Power Cord to an AC Power Supply in an
OCX1100 Switch
If the AC power source outlet has a power switch, set it to the off (
5.
Insert the power cord plug into an AC power source outlet.
6.
If the AC power source outlet has a power switch, set it to the on (
7.
Verify that the LEDs on each power supply are lit green.
8.
If the LED is lit amber, remove power from the power supply, and replace the power
supply (see
"Removing an AC Power Supply from an OCX1100 Switch" on page
Do not remove the power supply until you have a replacement power supply ready:
the power supplies or a cover panel must be installed in the switch to ensure proper
airflow.
CAUTION:
We recommend that you install either a replacement power
supply or a cover panel in an empty power supply slot to prevent chassis
overheating and dust accumulation.
AC Power Supply in OCX1100 Switches on page 23
Power Supply LEDs in OCX1100 Switches on page 27
The DC-powered models of (see
support 800 W DC power supplies. After you install at least one power supply, you can
connect power to the switch.
CAUTION:
Do not install:
"OCX1100 Switch Models" on page
Copyright © 2017, Juniper Networks, Inc.
) position.
O
|
) position.
111).
6) OCX1100 switches
Advertisement
Chapters
