Figure 30: Connecting An Ac Power Cord To An Ac Power Supply In A - Juniper PTX1000 Hardware Manual

See Also
Copyright © 2018, Juniper Networks, Inc.
Insert the coupler end of the power cord into the AC power cord inlet on the AC power
4.
supply faceplate (see Figure 30 on page
Figure 30: Connecting an AC Power Cord to an AC Power Supply in a PTX1000
If the AC power source outlet has a power switch, set it to the off (
5.
NOTE: The PTX1000 powers on as soon as power is provided to the power
supply. There is no power switch on the router.
Insert the power cord plug into an AC power source outlet.
6.
Repeat Step 4 through Step
7.
If the AC power source outlet has a power switch, set it to the on (
8.
Verify that the status LEDs on each power supply are lit green.
9.
If the status LED is lit amber, remove power from the power supply, and replace the
power supply (see "Removing a Power Supply from the PTX1000" on page
not remove the power supply until you have a replacement power supply ready: the
power supplies must be installed in the PTX1000 to ensure proper airflow.
CAUTION: Replace a failed power supply with a new power supply within
30 seconds of removal to prevent overheating of the chassis.
PTX1000 AC Power Supply Description on page 36
Chapter 3: Initial Installation and Configuration
75).
6 for each power supply that you are connecting to power.
) position.
O
) position.
|
90). Do
75