Pht- 1.0.0 "Get Neg Tmp" Lasting Forever/Isolate Uf Pump; Pht- 1.0.2 Strone Pulse(S) Seen; Pht- 1.0.3 "Get Neg Tmp" Still Up - Fresenius Medical Care 2008K2 Troubleshooting Manual

PHT- 1.0.0 "GET NEG TMP" LASTING FOREVER / ISOLATE UF PUMP
A) Call debug screen 1 to see ATMP (Figure right). It should
increase to about -250 during "Get Neg TMP" and if it does
"Neg Flow On" appears.
B) If the "Get Neg TMP" banner is still up see part C. If NOT
allow the Tests to finish THEN,
page 476
proceeed to
C) Figure right, remove the Fluid Sample Connector from its
port and hold it UP as shown!
D) ENSURING the "Get Neg TMP" banner REMAINS up,
watch for up to TWO (2) minutes or until you see a strong
pulse that squirts out more than six (6) feet?
Yes Strong pulse(s)! See procedure number
PHT- 1.0.2
No No strong pulse! TWO (2) possible scenarios 1) or 2) below:
1) IF (and ONLY if) "Get Neg TMP" is still up: Proceed to
SECTION 14 – UF PUMP PROBLEMS
2) ALL OTHER banners: Allow the Tests to finish then,
page 476
PHT- 1.0.2 STRONG PULSE(S) SEEN
ENSURING "Get Neg TMP" remains up, watch FILACT (middle
column) for one (1) minute. TWO (2) possible scenarios:
1) IF FILACT EVER = 1! A hydraulic air leak is indicated! See procedure number
475).
2) IF FILACT ALWAYS = 0: Is the "Get Neg TMP" banner still up?
Yes "Get Neg TMP" still up! See procedure number
No "Get Neg TMP" IS NOT up! Allow the Tests to finish then,
page 476

PHT- 1.0.3 "GET NEG TMP" STILL UP

a) Turn the machine off and remove the dummy chamber from the Level Detector module.
b) Turn the machine on and return to Dialysis Program ("Select Program" → 'Dialysis' → 'Enter')!
page 409
c) Proceed to
even if they pass
, procedure number
(page 475).
, procedure number PHT-
, procedure number PHT-
, SECTION 8 – FILLING PROGRAM PROBLEMS
2008K/K2 Troubleshooting Guide
P/N 507298 Rev. H
,
PHT- 1.5.0.
even if they pass
1.5.0.
PHT- 1.0.3
even if they pass
1.5.0.
page 503
,
, proceed to
PHT- 1.0.3 (page
(page 475).
, proceed to
Page 475