Nw- 1.0.0 Valve Error = 0; Section 2 - "No Water" Alarm - Fresenius Medical Care 2008K2 Troubleshooting Manual

A) ENSURE the water is on! If attached to a PORTABLE RO ENSURE it is on, alarm free AND NOT in
product divert!
B) ENSURE the incoming water line, between the 2008K/K
C) Call debug screen 0.
D) Ignoring the TOP Flow Error window, look at
down).
TWO (2) possible scenarios 1) or 2) below:
1) IF (and ONLY if) Valve Error = 0: See procedure number
2) IF Valve Error = 1 longer than two (2) seconds consistently: Refer to the Table below:
If the machine is CURRENTLY in:
Dialysis Program i.e. connected to
Acid and Bicarb
A Cleaning / Disinfection Program
(Rinse, Heat Disinfect, etc.)

NW- 1.0.0 VALVE ERROR = 0

a) Figure below, ENSURE the Vent Tubing is NOT kinked,
to the Float!
b) Is the machine attached to a PORTABLE RO? TWO (2) possible scenarios 1) or 2) next page:
SECTION 2 – "NO WATER" ALARM
Valve Error (2
Proceed to
2008K/K2 Troubleshooting Guide
P/N 507298 Rev. H
2
and the RO, is connected PROPERLY!
nd
window
NW- 1.0.0 (page 141).
Your response
page 652
Proceed to ,
page 189
, procedure number
INCLUDING
the short segment going back
Section 26
CLEAN- 7.0.0
Page 141