Tmp- 2.0.10 Tmp Window Red; Tmp- 2.0.11 Tmp Window Is Red But Tmp Is Stable - Fresenius Medical Care 2008K2 Troubleshooting Manual

1) IF (and ONLY if) WHITE: Proceed to
2) IF RED: See procedure number

TMP- 2.0.10 TMP WINDOW RED

a) TMP is UNSTABLE if ANY one or more of the three (3) conditions below occur:
Condition #1: Figure right, if a positive ('+') sign* appears in the TMP
Condition #2: If TMP does NOT remain between 0 and negative 450
Condition #3: If TMP changes more than 40 mmHg in one (1) minute
b) Is TMP UNSTABLE?
Yes TMP is unstable! Proceed to
No TMP is STABLE! i.e. no '+' sign AND TMP is between 0 and 450 AND is NOT changing more
than 40. See procedure number

TMP- 2.0.11 TMP WINDOW IS RED BUT TMP IS STABLE

a) Press and release the 'Reset' key then immediately press and hold it for three (3) seconds.
b) Allow thirty (30) seconds. What color is the TMP window now? TWO (2) possible scenarios:
1) IF (and ONLY if) WHITE: See procedure number
2) IF remaining RED: See parts a AND b below:
a) Per the Figure right, ENSURE BOTH
CONDITIONS below exist:
Condition #1: The Actual TMP bar is
Condition #2: The TMP window is RED!
b) If (and ONLY if) BOTH conditions exist AND after multiple RESET attempts the TMP window
remains RED, FOUR (4) possible bad components: 1) Actuator-Test Board OR; 2) Sensor
1
Board OR; 3) Functional Board
1
To prevent "Cond Offset Failure" place the machine into T and C Mode (refer to
OPERATING MODES
window.
* If a '+' sign does NOT appear TMP is negative!
mmHg (i.e. no '+' sign)
page 456
TMP- 2.0.11
remaining BETWEEN the
Upper (@ 520) and Lower
(@ 0) Alarm Limits!
1
OR; 4) Motherboard.
(page Error! Bookmark not defined.).
2008K/K2 Troubleshooting Guide
P/N 507298 Rev. H
page 456
, procedure number
TMP- 2.0.10 (page 455).
, procedure number TMP-
(page 455).
TMP- 2.0.16 (page 456).
TMP- 2.0.16.
2.0.16.
Page 455