Leaking- 2.0.0 Secondary Side Leak/Dialysate Sampling Option?; Leaking- 2.1.0 Dialysate Sampling = "Yes" - Fresenius Medical Care 2008K2 Troubleshooting Manual

LEAKING- 2.0.0 SECONDARY SIDE LEAK / DIALYSATE SAMPLING OPTION?
a) From the Service Mode menu, select the 'Options' button.
b) Select the 'Hardware Options' button.
c) Does the "Yes" box at Dialysate Sampling (Figure right) have a blue 'X'
in it?
Yes Dialysate Sampling = "Yes"! See procedure number
No Dialysate Sampling = "No"! This is NORMAL! In what Program, 1) Dialysis OR 2) A Cleaning
Program (Rinse, Heat Disinfect, etc.) was the leak ORIGINALLY seen?
1) IF (and ONLY if) in Dialysis Program: Turn the machine OFF then proceed to
560
2) IF in a Cleaning Program: Proceed to

LEAKING- 2.1.0 DIALYSATE SAMPLING = "YES"

a) Place the 'X' in the "No" box and press 'CONFIRM'.
b) ENSURE the "No" box at Dialysate Sampling now has a blue 'X' in it!
c) Turn the machine OFF then back on!
d) Return to the Program (Cleaning OR Dialysis) where the leak was
ORIGINALLY seen! In a Cleaning Program squirting into the bucket
occurs if (and ONLY if) UF Check Valve #63 is okay!
e) Figure right, if (and ONLY if) no leaks from the Fluid Sample port = UF
Check Valve #64 is okay!
f) Watch for up to four (4) FULL minutes OR until an active leak reoccurs. TWO (2) possible scenarios:
1) IF (and ONLY if) an active leak reoccurs: Turn the machine OFF then see procedure number
LEAKING- 3.2.0
2) IF an active leaks does NOT reoccur AND THREE (3) possible scenarios i) or ii) or iii below:
i) IF in a Cleaning Program AND a Flow Error occurs: Proceed to
number CLEAN-
ii) IF in Dialysis Program AND a Flow Error occurs: Proceed to
ERRORS IN DIALYSIS
iii) IF a Flow Error does NOT occur: The leak was probably due to the incorrect Dialysate
Sampling setting! This option should always be left at "No"!
, procedure number LEAKING-
560 .
(page )
1.2.0.
PROGRAM.
2008K/K2 Troubleshooting Guide
P/N 507298 Rev. H
LEAKING- 2.1.0
3.2.0.
page 559
, procedure number
page 158
page 20
(page 558).
page
LEAKING- 3.0.0.
, procedure
, SECTION 1 - FLOW
Page 558