Appendix B - Calibrate If Replaced - Fresenius Medical Care 2008K2 Troubleshooting Manual

APPENDIX B - CALIBRATE IF REPLACED

Components may need to be replaced to repair the machine. The following table
indicates calibrations that must be performed in this event.
Replaced Component
- Display Assembly (i.e. screen)
- Deaeration Pump Head (#20)
- Deaeration Motor (or if brushes are replaced)
- Loading Pressure Relief Valve (#78)
- Flow Pump Head (#21)
- Flow Motor (or if brushes are replaced)
- Flow Pressure Relief Valve (#78)
- Inlet Water Pressure Regulator (#61)
- Entire Balancing Chamber
- Acid Pump (#16)
- Bicarbonate Pump (#17)
- UF Pump (#22)
- Dialysate Pressure Transducer (#9)
- Temperature Sensor (NTC #2 or NTC #3)
- Post Dialyzer Temperature Sensor (NTC #44)
- Heater (#54)
- Blood Leak Detector (#8)
- Pre Dialyzer Conductivity Cell (#7)
- Post Dialyzer Conductivity Cell (#13)
- Functional Board (with new EEPROM)
- Actuator-Test Board
- Sensor Board
- Arterial Blood Pump Module
- Level Detector Module
2008K/K2 Troubleshooting Guide
Then Calibrate
- Touch Screen Calibration
- Deaeration and Loading
Pressure
- Flow Pressure
- Inlet Water Pressure
Regulator
- Balance Chamber Volume
- Acid Pump Volume
- Bicarbonate Pump Volume
- UF Pump Volume
- Dialysate Pressure
- Temperature Control
- Temperature Control
- Blood Leak
- Conductivity Cells
- Conductivity Cells
- All Calibrations
- Voltage Detection
- Arterial Pressure
- Venous Pressure
- Dialysate Pressure
- Temperature Sensor
- Post Temperature Sensor
- Temperature Control
- Blood Leak
- Conductivity Cells
- Arterial Pump Rate
- Venous Pump Rate
- Arterial Pressure
- Arterial Pump Rate
- Venous Pressure
- Level Detector
P/N 507298 Rev. H
K Calibration
Procedures Section #
2.1
2.2.1
2.2.2
3.1
2.2.3
2.2.4
2.2.5
2.2.6
2.3.3
2.3.6
2.3.6
2.3.7
2.3.8
2.3.8
All Sections
2.4.2
2.3.1
2.3.2
2.3.3
2.3.4
2.3.5
2.3.6
2.3.7
2.3.8
2.4.3
2.4.4
2.3.1
2.4.3
2.3.2
3.2
Page 668