T- 1.0.130 Temperature Window Is Pale/Yellow; T- 1.0.131 Temperature Window Less Than 30 Degrees C; T- 1.0.132 Verify Conductivity - Fresenius Medical Care 2008K2 Troubleshooting Manual

T- 1.0.130 [TEMPERATURE] WINDOW IS PALE/YELLOW
a) Figure right, at the distribution board, unplug the
connector from the LEFT, "MON-NTC"! This is temp
sensor NTC #3.
b) Based on the [Temperature] window, TWO (2) possible
scenarios:
1) IF (and ONLY if) LESS THAN 30.0° C: See procedure number
2) IF MORE THAN 30° C: If
LEFT, "MON-NTC", is unplugged AND [Temperature] is STILL more than 30.0° C proceed to
244
, procedure number
T- 1.0.131 [TEMPERATURE] WINDOW LESS THAN 30.0° C
a) Return NTC #3's connector to the
b) If NTC #3 was plugged in correctly [Temperature] RETURNS to between 35.1 and 38.9° C!
c) See procedure number

T- 1.0.132 VERIFY CONDUCTIVITY

ENSURE the shunt door is closed!
a)
b) Based on the [Conductivity] window, THREE (3) possible scenarios 1) or 2) or 3) below:
1) IF (and ONLY if) STABLE* between 13.0 and 14.5 mS AND the window is pale yellow/white:
See procedure number
* STABLE = NOT changing more than 0.2 mS per minute
2) IF (and ONLY if) less than 13.0 OR more than 14.5 mS: Proceed to
SECTION 5 – CONDUCTIVITY
3) IF STABLE* between 13.0 and 14.5 mS AND the window IS RED: See parts a THROUGH c
below:
a) At the bottom of the screen, select the
'Dialysate' tab (Figure right).
b) Figue right, if necessary, adjust the Alarm
Limits until 'Actual' Conductivity is CENTERED
between them.
c) Press 'CONFIRM'! Is the [Conductivity]
window white?
ABSOLUTELY SURE
T- 1.4.0.
nd
2
distribution board position from the LEFT, "MON-NTC".
T- 1.0.132 (page 225).
T- 1.0.133 (page 226).
PROBLEMS.
2008K/K2 Troubleshooting Guide
P/N 507298 Rev. H
nd
2
T- 1.0.131
the connector at the
(page 225).
nd
2
position from the
page 317
,
Page 225
page