Status Messages - Dräger Infinity Delta Instructions For Use Manual

21 R
ESPIRATORY

Status Messages

Message
PIP > #
PEEP > #
PEEP < #
MVe < #
RRv: APN
Flow:
• Adult/Pediatric
Sensor
• Pediatric Sensor
• Neonatal Sensor
Flow: Invalid Sensor
Flow: Purge in
Progress
Flow: Unable to Zero;
Purge Sensor
Flow: Sensor
Disconnected
Flow:
H/W Problem
Flow: Purge Timeout
CO2/Flow Pod
Disconnected
Duplicate Device
Connected
21-24
M
ECHANICS
Condition
The PIP value is above the alarm limits.
NOTE: A PIP alarm can only occur if a valid
sensor is connected and the PIP alarm has
been enabled.
The PEEP value is above or below the alarm
limits.
NOTE: The PEEP and MVe alarms are not
available until a sensor is connected and a
valid Respiratory Rate (RRv) becomes
available.
The MVe value is below the alarm limit.
NOTE: PEEP and MVe alarms are not
available until a sensor is connected and a
valid Respiratory Rate (RRv) becomes
available.
An apnea based on flow measurements
Indicated Flow or CO2/Flow sensor
connected.
An unknown sensor is connected.
Purging flow sensors and tubing.
Flow or pressure sensor zero failed.
Flow sensor is disconnected.
Hardware failure.
Purge time has exceeded standard limits.
The etCO /Respiratory Mechanics pod is
2
disconnected.
A device that duplicates the pod's monitoring
capabilities is connected.
D /D
ELTA ELTA
Suggested action
Check the patient and the
ventilator settings.
Check the patient and the
ventilator settings.
Check the patient and the
ventilator settings.
Check the patient and the
airway circuit.
Verify that the flow or the
etCO
matches the patient
category.
Replace the sensor.
None
• Check the tubing.
• Initiate manual purge.
• Connect the sensor.
• Check the airway circuit.
• Contact DrägerService
representative.
• Check the tubing.
• Initiate a manual purge.
Connect the pod.
Disconnect the duplicate
device.
XL/K
APPA
/flow sensor type
2
VF8