Calibration; Quick Reference Table - Etco2 Setup - Dräger Infinity Delta Instructions For Use Manual

Quick Reference Table – etCO2 Setup
The following table explains Microstream pod etCO
Function Description
Scale Determines size of currently displayed
waveform.
Respiratory Sets waveform sweep speed on screen
Sweep Speed display.
Averaging Sets interval for CO
NOTE: The monitor reports the
maximum value of etCO
specified sampling interval.
etCO2 Alarm Accesses Alarm Limits table, where you
can set upper and lower alarm
thresholds.See chapter 5, Alarms, for
information about setting and displaying
alarm limits.
BTPS (body User selectable correction factor.
temperature,
pressure,
saturation)
Last Cal Displays the last calibration date of the
pod (read only).

Calibration

Calibration of the Microstream pod is not necessary unless the calibration check fails.
A calibration check should be performed when the monitor displays the advisory
message Calibration Required. An initial calibration is requested after the first 1,200
operating hours. Afterwards, calibration is required annually or at 4,000 operating
hours, whichever is first.
Calibration is a Biomed function and is password protected. Consult your hospital's
technical personnel for further information.
VF8 D
measurements.
2
2
/D XL/K
ELTA ELTA
setup functions.
2
Settings
• 40 mmHg
• 60 mmHg
• 80 mmHg
• 100 mmHg
• 6.25 mm/s
• 12.5 mm/s
• 25 mm/s
• 50 mm/s
• Breath-Breath
• 10 s
• 20 s (default)
during the
• 30s
Not applicable
• On (default)
• Off
Not applicable
APPA
C
ALIBRATION
20-7