Replacing Recorder Paper - Dräger Infinity Delta Instructions For Use Manual

7 R
ECORDINGS
To assign recorders
1. Press the
2. Click on
3. Click on
4. Click on
5. Scroll through the numbers and click successively on the single digits of the
clinical password. If you make a mistake, click on
6. Click on
7. Click on
8. Click on the desired recorder.
9. Click on
10. Click on the desired recorder.
NOTE:

Replacing Recorder Paper

When the recorder is about to run out of paper, a red line appears on the recording
strip. Replace the paper as soon as possible to provide continued operation.
To replace the recorder paper:
1. Open the paper door.
2. Pull out the paper roll from the spool holder.
3. Remove any paper remaining in the printing mechanism.
4. Place the new paper roll into the spool holder. Unroll a few inches of paper
from the bottom. The printed side should be facing up.
5. Align the paper roll with paper guides. If not aligned, paper could jam.
6. Close the paper door.
7. To verify positive results, generate a timed recording (see page 7-6).
7-10
fixed key to display the Main menu.
Menu
Monitor Setup.
.
Recordings
. A data entry window appears.
R50 Assign
to open the R50 Assign menu.
Accept
Primary Recorder
Secondary Recorder
Recorder names are assigned by DrägerService when the Infinity network is
configured.
If your monitor and recorders are not networked, contact DrägerService to
configure the recorder.
D /D
ELTA
to display available recorders.
.
XL/K
ELTA APPA
and try again.
Backspace
VF8